Changes to Step #158
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
- | [* black] Last photo, apply pressure to the spring/trigger when doing final tightening to make sure the black/clear pieces are lined up right |
---|---|
+ | [* black] Insert the 4x M3x10mm long phillips screws through the ezr struder into the motor. Tighten these screws snug but do not fully tighten yet. |
+ | [* black] When all 4 screws are snug, as seen in Pic 3, apply pressure to the red lever on the ezr struder. |
+ | [* black] While applying pressure to the red lever, fully tighten the 4 screws to secure the ezr struder to the motor. This will make sure the plastic parts are aligned properly. |