Changes to Step #156
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
- | [* icon_caution] If you purchased the dual extrusion add-on kit, it may be beneficial to install it at this stage as well. |
---|---|
+ | [* black] Here we will be installing the extruder to the mounting plate. You will use the final remaining motor, the ezr struder body, the silver ezr knob, hobbed drive roller, allen key, 4x M3x10mm long screws, 2x 6-32 x 7/8" long phillips screws and 2x 6-32 nylon insert lock nuts. |
+ | [* black] First you will want to cut and remove the zip tie holding together the ezr struder as shown in Pic 2. Discard the zip tie. |