Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #155

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] First photo is making sure terminal gates are fully open before inserting the wires
+[* black] The wires will go to the duet on the side with the motor plugs and go into the two positions closest to the white connector as shown in pic 1.
+[* black] You will want to loosen the screws in the terminal before inserting the wires as they typically come closed and will need to be opened.
+[* black] With the terminals open, insert the black wire into the position closest to the white connector and tighten to secure it.
+[* black] The red wire will go into the next position next to the black wire as shown in Pic 3.
+[* icon_caution] The green terminals will want to twist on the board when tightening the terminal. Hold the terminal in place with your fingers to prevent the connector from twisting while tightening.