Changes to Step #118
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
- | [* black] Insert wisdom here. |
---|---|
+ | [* black] Flip the sheet metal frame upside down so the bottom is facing up so you can work on it. |
+ | [* black] Put the small shim on the endstop side of the motor bracket as shown in Pic 2. There is a notch in the shim to allow the endstop switch to be not blocked. Pay attention to this orientation. |
+ | [* black] Using the 6-32 x 7/8" long screws, secure the motor brackets to the top frame as shown in Pic 3. |