Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #115

Edit by Andy Oprisko

Edit approved by Andy Oprisko


Step Lines

+[title] Prep Endstop Wiring
[* black] This section will use the 3 idler brackets with motors installed that were made at the beginning of the guide. You will also use 3 small shims, 6x 6-32 x 7/8" long philips screws, 6x black endstop wires with pre-crimped connectors, and 3x 3 pin white connectors.
[* black] Insert the crimped end of 2 wires into a white connector as shown in Pic 2. The crimp will push fully into the connector until you hear a click to lock it in.
[* icon_caution] There are going to be 2 wires going into the 3 pin connector. The positions on the connector to use are the outermost locations. There will be NO wire in the center position of the 3 pin connector!
[* black] Repeat this process with the other wires so you have 3 pairs of wires with a 3 pin connector on them as shown in Pic 3.