Changes to Step #115
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
- | [* black] This section will use the 3 idler brackets with motors installed that were made at the beginning of the guide. You will also use 3 small shims, 6x |
---|---|
+ | [* black] This section will use the 3 idler brackets with motors installed that were made at the beginning of the guide. You will also use 3 small shims, 6x 6-32 x 7/8" long philips screws, 6x black endstop wires with pre-crimped connectors, and 3x 2 pin white connectors. |
[* black] Insert the crimped end of 2 wires into a white connector as shown in Pic 2. The crimp will push fully into the connector until you hear a click to lock it in. | |
[* black] Repeat this process with the other wires so you have 3 pairs of wires with a 2 pin connector on them as shown in Pic 3. |