Changes to Step #92
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
+ | [title] Prep Base Fan |
---|---|
[* black] This step will use the lower sheet metal, the 60mm x 60mm x 25mm fan from the electronics pack, 4x M3 x 35mm long phillips screws from the lower hardware pack, and 4 o-rings from the lower hardware pack. You will also need 4x M3 nylon lock nuts and 4 washers. | |
[* black] Cut off the white plug from the fan as close to the plug as possible and discard this plug as shown in Pic 2. | |
[* black] Strip about 10mm of the ends of each wire from the fan as shown in Pic 3. |