Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #92

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[* black] This step will use the lower sheet metal, the 60mm x 60mm x 25mm fan from the electronics pack, 4x M3 x 35mm long phillips screws from the lower hardware pack, and 4 o-rings from the lower hardware pack.
+[* black] Cut off the white plug from the fan as close to the plug as possible and discard this plug as shown in Pic 2.
+[* black] Strip about 10mm of the ends of each wire from the fan as shown in Pic 3.