Changes to Step #85
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
+ | [title] Install Bed Thermistor |
---|---|
[* black] This step you will need the Heated bed with aluminum heat spreader, the remaining M3 x 10mm long flat head screw, #4 washer, and the thermistor setup you made in the previous step. | |
[* black] Using the bottom most hole on the bed that is by itself, insert the screw through the washer and through the bed and screw it into the thermistor holder as shown in Pic 2. |