Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #85

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[* black] This step you will need the Heated bed with aluminum heat spreader, the remaining M4 x 10mm long flat head screw, #4 washer, and the thermistor setup you made in the previous step.
+[* black] Using the bottom most hole on the bed that is by itself, insert the screw through the washer and through the bed and screw it into the thermistor holder as shown in Pic 2.