Changes to Step #84
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
[title] Prep Bed Thermistor | |
- | [* black] Insert the stripped ends of the thermistor into the spring clip. |
- | [* black] You will put one leg of the thermistor in each side of the connector as shown in Pics 1 and 2. |
- | [* black] You will now have an assembled thermistor setup as shown in Pic 3. |
+ | [* black] Plug the thermistor into the supplied thermistor PCB as shown in Pic 1. |
+ | [* black] This PCB is a jumper between the thermistor and the thermistor wiring that goes to the main electronics board. |
Image 1
Old Version
New Version
Image 2
Deleted
Image 3
Deleted