Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #82

Edit by Andy Oprisko

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

-[* black] We will now be prepping the heated bed parts. You will use the cartridge thermistor, aluminum thermistor housing, white 2 position lever wire connector, 2x M4 x 10mm long flat head screws, and one washer for this step.
+[* black] We will now be prepping the heated bed parts. You will use the cartridge thermistor, aluminum thermistor housing, white 2 position lever wire connector, 2x M3 x 10mm long flat head screws, and one washer for this step.
[* black] Cut off the white 2 pin connector from the thermistor as close to the connector as possible as shown in Pic 2.
[* black] Strip about a half inch of the thermistor ends exposing the wire as shown in Pic 3.