Changes to Step #77

Edit by Andy Oprisko

Edit approved by Andy Oprisko


Step Lines

-[* black] X Tower
+[* black] In this step you will get another extrusion piece for the X tower.
+[* black] Install the extrusion for the X tower the same way you did with the previous tower.
+[* black] There are no wires that go through this tower.
+[* black] Install the tower in the location at the back of the power supply and tighten the button head screws tightly.
+[* black] Use another small shim piece and place it on top of the brackets like in the previous step.