Changes to Step #61

Edit by Andy Oprisko

Edit approved by Andy Oprisko


Step Lines

-[* black] Insert wisdom here.
+[* black] Locate the solid state relay from the electronics pack.
+[* black] Remove the clear top cover and you will use the remaining 2 M3 x 10mm long screws from the lower hardware pack and 2 M3 lock nuts.
+[* black] Line up the solid state relay next to the power supply as shown in Pic 3. Make sure the orientation of the relay is as shown in the picture with the output of the relay towards the center of the machine, and the input towards the edge of the machine.