Changes to Step #45
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
+ | [title] Install Printer Feet cont. |
---|---|
[* black] Flip the assembly upside down to stand on the brackets. | |
[* black] Make sure all 6 nylon screws are securely tightened down. Be careful not to over tighten as that can strip the nylon screw. | |
[* black] The rubber feet are a press fit over the black plastic feet. | |
[* black] Press on all 6 rubber feet over the black plastic feet and snap them into place. |