Skip to main content

Changes to Step #21

Edit by Andy Oprisko

Edit approved by Andy Oprisko


Step Lines

-[* black] Insert wisdom here.
+[* black] Set the motor to the counter clockwise location as shown in Pic 1. The screws should be snug enough to hold its position, but loose enough you can rotate the motor along the slots.
+[* black] Using the small bracket, align the pegs of the large bracket to attach the halves together. The pegs will go into the idler bearings to align.
+[* black] Using 2 sheet metal screws, insert one screw in each hole of the small bracket circled in Pic 3.
+[* black] Repeat this on all 3 brackets.