Changes to Step #13
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
[* black] You will now be assembling the top motor brackets. For this step you will have 3 piles of parts as shown in Pic 1. | |
- | [* black] Each pile will consist of one endstop, a large and small bracket plate, 2 idlers, 4 lock nuts, 4 t-nuts, 4 large hex key bolts, a motor with pulley, 2 sheet metal screws, 3 M3 threaded screws with washers, and 2 thin #4 threaded screws. |
+ | [* icon_note] The lock nuts should have already been installed in the black brackets in step 5. |
+ | [* black] Each pile will consist of one endstop, a large and small bracket plate, 2 idlers, 4 lock nuts (already installed in previous step!), 4 t-nuts, 4 large hex key bolts, a motor with pulley, 2 sheet metal screws, 3 M3 threaded screws with washers, and 2 thin #4 threaded screws. |
[* black] Remove the metal tab from the endstop as shown in Pics 2 and 3. Discard this metal tab as it will not be used. |