Changes to Step #12
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
[title] Install pulleys on motors. | |
[* icon_caution] Be sure to tighten BOTH set screws | |
- | [* black] You will notice the shaft of the motor does not fully come to the end of the pully. This is normal. |
+ | [* black] You will notice the shaft of the motor does not fully come to the end of the pully. This is normal. The bottom of the pulley should be sitting approximately 8-9mm from the black flat of the motor. |
[* black] Tighten down both set screws on the motor making sure one of the set screws is aligned with the flat part of the motor shaft. | |
[* black] Repeat the process on the other 2 motors so all 3 motors have the pulleys on them. |