Changes to Step #12
Edit by Andy Oprisko —
Edit approved by Andy Oprisko
- Before
- After
- Unchanged
Step Lines
- | [* black] Insert wisdom here. |
---|---|
+ | [title] Install pulleys on motors. |
+ | [* icon_caution] Be sure to tighten BOTH set screws |
+ | [* black] You will notice the shaft of the motor does not fully come to the end of the pully. This is normal. |
+ | [* black] Tighten down both set screws on the motor making sure one of the set screws is aligned with the flat part of the motor shaft. |
+ | [* black] Repeat the process on the other 2 motors so all 3 motors have the pulleys on them. |