Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #11

Edit by Sudhir

Edit approved by geneb

Before
After
Unchanged

Step Lines

[title] Install Pulleys
[* black] You will insert a pulley onto the motor as shown in Pic 2. There is a flat section on the motor shaft, and you will line the set screw up with this flat so it is tightened onto the flat.
-[* black] You will insert the pulley as shown in pic 3 to the depth it is shown. The top arrow shows the flat of the motor almost alinged with the base of the pulley. This is where you want to tighten the set screws.
+[* black] You will insert the pulley as shown in pic 3 to the depth it is shown. The top arrow shows the flat of the motor almost aligned with the base of the pulley. This is where you want to tighten the set screws.