Changes to this Step
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Preparing Wires |
|---|---|
| + | [* 1] There are reliefs in the T-Slot for the wires so they do not get pinched between the towers and the aluminum plate. On the bottom of the machine only the Z tower has wires exiting the tower. |
| + | [* 1] Fold the wires over into that channel in the T-Slot and hold them there to give them some memory. |
| + | [* 1] The next part of this step will be helpful if you can have a second set of hands. |
| + | [* 1] Orient the front of the base assembly with the front of the upper assembly. |
| + | [* 1] Feed the wires from the Z Tower into the Z tower location of the base Assembly. These wires will feed in towards the center of the bed. Bunch the wires together (as performed in the top assembly) so they will remain in the relief in the T-Slot. |
| + | [* 1] Pull the wires toward the center of the heated bed as you gently set the bottom assembly down onto the three towers. Take care not to scratch the sheet metal cover. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added