Changes to this Step
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] [Optional FSR Only] Install SL Connector |
|---|---|
| + | [* 1] At the bottom of the Z Tower, install a Molex SL Connector on the 3 probe wires (26awg White, Black, Red). These will be installed in the black 3 pin SL connector. |
| + | [* 1] In the picture with the green circle the "Tab" on the SL connector is being highlighted. This tab is what latches in the "window" of the connector to prevent it from coming out. You must orient the wires correctly when inserting them or the wire will come out. |
| + | [* 1] On the connector housing pin 1 is indicated with an arrow. Insert the black wire into pin 1, red wire into pin 2 (Middle), white wire into pin 3. Push each of the wires in until you feel a "click". You will see that small tab, in the window of the connector when they are fully inserted. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added