Changes to this Step
Edit by Caleb Fairres —
Edit approved by Caleb Fairres
- Before
- After
- Unchanged
Step Lines
| + | [title] Feeding the Wires in the Z Tower |
|---|---|
| + | [* 1] The first set of wires to feed in the Z Tower are the 18awg wires. These are the thicker wires from the Z Tower Wire Pack. Please ensure to have them oriented the correct way. |
| + | [* 1] You will feed from the bottom of the tower (opposite the stepper motor). Feed the following: 18awg white and green wire with ring terminal, 18awg black wire with straight spade terminal, 18awg wire with NO terminal. |
| + | [* 1] These wires can be fed by pushing small bits at a time. If you feel resistance, back the wires out about 25mm and then try pushing forward again. |
| + | [* 1] Ensure you get the same number of wires exiting the end the end of the tower that you started feeding. |
| + | [* 1] Now run the remaining wires. This is easiest using a piece of filament to pull wire. |
| + | [* 1] Run the included mesh loom over the wires and secure with a zip tie. This is to secure the wires for later steps. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added