Changes to this Step

Edit by Andy Oprisko —

Edit approved by Andy Oprisko

Before
After
Unchanged

Step Lines

+[title] Configure Extruder 1
+[* 1] Set nozzle size to 0.5 *This is our stock nozzle size, if you are using a different nozzle size, put the correct nozzle size here*
+[* 1] Set filament size to 1.75
+[* 1] In "Extruder End G-Code" match in the picture. You will add the line "G1 X0 Y80 F20000"
+[* 10] This is where knowledge of the printer comes in. The extruder end G-Code is used to move away from the print to swap filament. If your print is in this area, use a different X / Y coordinate to avoid any ooze on your print.

Image 1

No previous image

New image

Added