Skip to main content

Changes to 2018 HE280 Assembly Introduction

Edit by geneb

Edit approved by geneb

Before
After
Unchanged
Introduction
This guide will show you how to assemble the HE280 hot end and effector platform. Note that these instructions only cover the HE280 as shipped during and after March of 2018.
If you're not sure when your HE280 was shipped, you can easily tell. The pre-March 2018 units have a thermal fuse and the thermistor is a glass bead. The newer HE280's have a cartridge-encapsulated thermistor and no thermal fuse.

Tools

  • Soldering Iron x1 added.
  • Solder x1 added.
  • Phillips Screwdriver, size P1 x1 added.
  • X-Acto or Razor Knife x1 added.
  • Simple Crimping Tool x1 added.

Steps

Step #: 1
Before
After
Step #: 2
Before
After
Step #: 3
Before
After
Step #: 4
Before
After
Step #: 5
Before
After
Step #: 6
Before
After
Step #: 7
Before
After
Step #: 8
Before
After
Step #: 9
Before
After
Step #: 10
Before
After
Step #: 11
Before
After
Step #: 12
Before
After
Step #: 13
Before
After
Step #: 14
Before
After
Step #: 15
Before
After
Step #: 16
Before
After
Step #: 17
Before
After
Step #: 18
Before
After
Step #: 19
Before
After
Step #: 20
Before
After
Step #: 21
Before
After
Step #: 22
Before
After
Step #: 23
Before
After
Step #: 24
Before
After
Step #: 25
Before
After
Step #: 26
Before
After
Step #: 27
Before
After
Step #: 28
Before
After
Step #: 29
Before
After
Step #: 30
Before
After
Step #: 31
Before
After
Step #: 32
Before
After